Material Range

We manufacture products of sizes between 1mm to 55mm from brass, aluminium, copper, steel (EN1A, EN8, EN9, EN19); stainless steel (SS303, SS304); silver steel and plastic (PVC, nylon, acetate, vescolite, polyethylene)

Bolts are for the assembly of two non-threaded components, with the aid of a nut. Screws in contrast are used with components, at least one of which contains its own internal thread, which even may be formed by the installation of the screw itself. Many thread fasteners can be described as either screws or bolts, depending on how they are used.

Our Mass Production Capabilities Allow Us to Produce a Vast Variety of Bolts

A nut is a type of fastener with a threaded hole. Nuts are almost always used opposite a mating bolt to fasten a stack of parts together. The two partners are kept together by a combination of their threads' friction, a slight stretch of the bolt, and compression of the parts.

A washer is a thin plate (typically disk-shaped) with a hole (typically in the middle) that is normally used to distribute the load of a threaded fastener, such as a screw or nut. Other uses are as a spacer, spring (Belleville washer, wave washer), wear pad, preload indicating device, locking device, and to reduce vibration (rubber washer). Washers usually have an outer diameter (OD) about twice the width of their inner diameter.

Contact Your Spacer & Insert Specialists